Linear Machine - LM10
Two columns testing machine with electric actuator on the upper crossbeam and lower grooved base.
Possibility to anchor the load cell on the actuator or on the base.
Very high dynamic performance up to 80 Hz.
LM10 Brochure
LM10 Video
Layout
Dimensions
Image
Flessione Rotante - RB35
Rotary bending machine at constant load.
Electromechanical machine with integrated system in a tubular steel base with a polycarbonate protection casing. Command, control and management of the test from Personal Computer
RB35 Brochure
RB35 Video
Layout
Thermal Image
Ortho 3
Triaxial biomechanical simulator for orthopaedic prostheses.
The frame consists of 4 columns and an electric actuator under the lower base; it is possible to anchor the load cell both on the lower base or on the upper crossbeam.
6-axis load cell (Fx-Fy-Fz e Mx-My-Mz).
Vertical force: 10 kN.
Axial moment: horizontal 100 Nm, vertical 100 Nm.
Very high vertical dynamic performance.
Ortho 3 Brochure
Creep - TCR30
Uniaxial Tensile, Creep and Relaxation mechanical tests on metallic materials.
The machine consists of a frame with four high-rigidity columns sustained by anti-vibration supports. The actuator with servo-mechanical control for the application of the load is mounted on the lower base.
Load capacity in tension up to 50 kN with heating furnace up to Tmax ~ 1200°C.
Creep Brochure
Layout
Heating Furnace
Electric Panel
Ultrasonic VHCF - MU26
Electromechanical testing machine with an ultrasonic system for stress generation and a load frame with electromechanical actuator to generate static stresses. Command, control and management from Personal Computer.
MU26 Brochure
MU26 Video
Layout
Slow Strain Rate 100 - SSR100
Slow deformation testing machine, floored frame with two columns and electric actuator on the lower base.
Possibility to anchor the load cell on the electric actuator or on the upper crossbeam.
Test speed range: from 0,001 mm/min to 5 mm/min with 100 kN.
SSR100 Brochure
Layout
Electric Actuator
Gear Test Machine - GTM600
Evaluate the wear resistance of the gear tooth face using lubricating fluid.
In particular, it is used for comparative tests on different surface treatments of the teeth.
At the end of the test, a visual assessment of the tooth surface and the gear weight loss are noted.
Alternatively, it can be used as a comparative test for the effectiveness of various types of lubricating oils, keeping the same gear fixed.
GTM600 Brochure
Anello chiuso in torsione
Ingranaggi in prova